Can you plaster over Artex?
Many textured ceilings can be given a smooth plastered finish, either by preparing and skimming the existing surface or by overboarding it first.
The right approach depends on the condition of the ceiling and, importantly, whether the existing textured coating could contain asbestos.
Can Artex contain asbestos?
“Artex” is commonly used to describe textured decorative coatings, although there are many different products and finishes.
Older textured coatings can contain asbestos. HSE says asbestos may be present in residential and commercial buildings constructed or refurbished before 2000 and specifically lists textured coatings on walls and ceilings as one of the places it can occur.
You cannot determine whether a coating contains asbestos simply from its appearance.
If a suspect surface is going to be disturbed and its status is uncertain, it should be assessed appropriately before the work proceeds.
For official information, see the Health and Safety Executive's asbestos guidance.
Can textured coating simply be skimmed?
Sometimes.
Before applying plaster over an existing ceiling, the surface needs to be capable of supporting the new finish.
That means considering the condition and adhesion of the coating beneath it as well as the ceiling itself.
A textured surface that is firm and stable presents a very different situation from one that is flaking, heavily cracked, water-damaged or poorly bonded.
Simply adding new plaster does not make a failing background sound.
When might overboarding be a better option?
Overboarding involves installing new plasterboard beneath the existing ceiling and finishing the new board rather than relying on the textured surface as the plastering background.
It can be useful where the existing finish is unsuitable for direct skimming or where a new, consistent surface is preferable.
However, it should not be described as automatically “asbestos-free” work. Fixings and other parts of the installation can still involve interaction with the existing ceiling, so the condition and potential asbestos risk must still be considered.
HSE notes that even work involving textured coatings can require specific asbestos awareness, controls and working methods depending on what is being disturbed.
Should Artex be scraped off before plastering?
Not as a general DIY preparation step.
Scraping, sanding or grinding a textured coating increases disturbance of the material. If its composition is unknown, doing that before an assessment is unnecessary and potentially unsafe.
The preparation method should be decided after the ceiling has been considered as a whole.
What if the ceiling is cracked?
A few fine cracks do not necessarily mean the whole ceiling needs replacing.
What matters is why the cracking has occurred and whether the ceiling and finish remain securely fixed.
Wider cracking, sagging, movement, water damage or loose areas may point towards a different solution from a simple skim.
Those issues need assessing rather than concealing.
What do we look at before recommending a method?
For an initial assessment, useful photographs include:
- the complete ceiling
- close-ups of the texture
- any cracks
- stains or water damage
- loose or damaged sections
- the junctions around lights and edges
We also need an idea of the property's age and whether anything is known about the existing coating.
From there, we can advise whether direct plastering, overboarding or further investigation is likely to be appropriate.
Want a smooth ceiling?
Send us photographs of the complete ceiling and any damaged areas. If there is a potential asbestos issue, we will not recommend disturbing the surface without it being addressed appropriately first.

